Effetto Mariposa Giustaforza Tool I Torque Popular products Set 2-16 Pro Wrench /brotherly525831.html,Mariposa,Effetto,sodj.jp,Wrench,Giustaforza,Tool,|,Set,Sports Outdoors , Outdoor Recreation , Cycling,Pro,$168,Torque,2-16,I Effetto Mariposa Giustaforza Tool I Torque Popular products Set 2-16 Pro Wrench $168 Effetto Mariposa Giustaforza Tool I 2-16 Pro Torque Wrench Set | Sports Outdoors Outdoor Recreation Cycling /brotherly525831.html,Mariposa,Effetto,sodj.jp,Wrench,Giustaforza,Tool,|,Set,Sports Outdoors , Outdoor Recreation , Cycling,Pro,$168,Torque,2-16,I $168 Effetto Mariposa Giustaforza Tool I 2-16 Pro Torque Wrench Set | Sports Outdoors Outdoor Recreation Cycling
Capacity from 2 up to 16 Nm Easy to use Set the desired torque rotating the wrench end knob, reading the torque value on the scale (scale resolution is 0.5 Nm, integers on one side, .5 on the other). IMPORTANT: the thicker line on the dial should be centered on the desired value on the scale; insert the appropriate bit (depending on the bolt you need to tighten); using the tool, a loud âCLICKâ and a 3Â° free-movement tells when the torque has been reached; always take the wrench to minimum torque value after use. Ratcheting head For a higher productivity in professional applications, Giustaforza 2-16 Pro has a very small ratcheting head, with 1/4â³ square (1/4â³ square/hex adapter provided, to be able to use standard bits). Lightweight The light aluminum body keeps the weight below 200 g, less than half the weight of other torque wrenches in this range of torque. This is paramount to get the right feedback at low torque values, without mistaking the effort to hold the tool with the applied torque. A state-of-the art tool, built to last Functional, linear in design and precise in any detail: Giustaforza 2-16 Pro has a hard-anodized aluminum body with laser-etched inscriptions, and itâs built to last. The mechanical, click-type functioning makes the wrench extremely shock tolerant and the absence of batteries or electronics increase its reliability. Each sample is checked and numbered as a single masterpiece Calibration service The +-4% tolerance is guaranteed for 5000 cycles (5000 âclicksâ), then the wrench should be re-calibrated. Calibration is a service we offer in our laboratory in Lugano (Switzerland) at the cost of 50 CHF plus shipping expenses (may vary depending on the countries: check terms amp; conditions with the national distributor). With every calibration, the tolerance of +-4% over nominal value will extend for 5000 cycles. After calibration, the wrench will return to the customer with a calibration certificate.